Specifications

Confidential
SHEET
195
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
196
FS S n1 n2
[Name] Set left- and right-side Kanji character spacing
[Format] ASCII FS S n1 n2
Hex 1C 53 n1 n2
Decimal 28 83 n1 n2
[Range] 0 ≤ n1 ≤ 255
0 ≤ n2 ≤ 255
[Description] Sets left- and right-side Kanji character spacing to n1 and n2, respectively.
• When the printer model used supports GS P, the left-side character spacing is
[n1 × horizontal or vertical motion units], and the right-side character spacing is
[n2 × horizontal or vertical motion units].
[Details] • When double-width mode is set, the left- and right-side character spacing is
twice the normal value.
• The horizontal and vertical motion units are set by GS P. The previously
specified character spacing does not change, even if the horizontal or vertical
motion unit is changed using GS P.
• The value cannot be less than the minimum horizontal motion amount, and must
be in even units of the minimum horizontal motion amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in page mode,
depending on starting position of the printable area, as follows:
① When the starting position is set to the upper left or lower right of the printable
area using ESC T, the horizontal motion unit (x) is used.
② When the starting position is set to the upper right or lower left of the printable
area using ESC T, the vertical motion unit (y) is used.
[Default] For paper roll: n1 = 0, n2 = 0
For slip: n1 = 0, n2 = 2
[Reference] GS P