Specifications

Confidential
SHEET
166
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
167
GS \ n
L
n
H
[Name] Set relative vertical print position in page mode
[Format] ASCII GS \ n
L nH
Hex 1D 5C n
L
n
H
Decimal 29 92 n
L
n
H
[Range] 0 ≤ n
L
≤ 255
0 ≤ n
H
≤ 255
[Description] Sets the relative vertical print starting position from the current position in page
mode.
• This command sets the distance from the current position to [(n
L
+ n
H
× 256)
× vertical or horizontal motion unit] inches.
[Details] • This command is ignored unless page mode is selected.
• When pitch N is specified for the movement downward:
n
L
+ n
H
× 256 = N
When pitch N is specified for the movement upward (the negative direction), use
the complement of 65536.
When pitch N is specified for the movement upward:
n
L
+ n
H
× 256 = 65536 - N
• Any setting that exceeds the specified printing area is ignored.
• The horizontal and vertical motion units are specified by GS P.
• The GS P command can change the horizontal (and vertical) motion units.
However, the value cannot be less than the minimum horizontal motion amount,
and it must be in even units of the minimum horizontal motion amount.
• This command functions as follows, depending on the print starting position set
by ESC T:
①
When the starting position is set to the upper left or lower right of the printing,
the vertical motion unit (y) is used.
②
When the starting position is set to the upper right or lower left of the printing
area, the horizontal motion unit (x) is used.
[Reference] ESC $, ESC T, ESC W, ESC \, GS $, GS P, 3.12 Page Mode