Specifications
Confidential
SHEET
163
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
164
①
①①
① GS V m ②
②②
② GS V m n
[Name] Select cut mode and cut paper
[Format]
①
ASCII GS V m
Hex 1D 56 m
Decimal 29 86 m
②
ASCII GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
[Range]
①
m = 1, 49
②
m = 66, 0 ≤ n ≤ 255
[Description] Selects a mode for cutting paper and executes paper cutting. The value of m
selects the mode as follows:
m
Print mode
1, 49 Partial cut (one point left uncut)
66
Feeds paper (cutting position + [n × (vertical motion unit)]), and cuts the paper
partially (one point left uncut).
[Details for
①
and
②
]
• This command is ignored when slip paper is selected as the print source by ESC
c 0.
• This command is effective only when processed at the beginning of a line.
[Details for
①
]
• Only the partial cut is available; there is no full cut.
[Details for
②
]
• When n = 0, the printer feeds the paper to the cutting position and cuts it.
• When n ≠ 0, the printer feeds the paper to (cutting position + [n × vertical motion
unit]
)
and cuts it.
• The horizontal and vertical motion units are specified by GS P.
• The paper feed amount is calculated using the vertical motion unit (y
)
. However,
the value cannot be less than the minimum horizontal motion amount, and it
must be in even units of the minimum horizontal motion amount.