Specifications

Confidential
SHEET
139
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
140
ESC f t1 t2
[Name] Set slip paper waiting time
[Format] ASCII ESC f t1 t2
Hex 1B 66 t1 t2
Decimal 27 102 t1 t2
[Range] 0 ≤ t1 ≤ 15
0 ≤ t2 ≤ 64
[Description] Sets the time that the printer waits for slip paper to be inserted and the time from
insertion of the slip to the start of printing.
• t1 specifies the wait time for slip paper to be inserted.
• t2 specifies time from insertion of the slip to the start of printing.
[Details] • This command sets the slip paper wait time to [t1 × 1] minutes. If slip paper is not
inserted within this time, the printer cancels slip paper mode and selects the
paper roll.
• When t1 is set to 0, the printer waits until slip paper is inserted.
• The printer starts operation [t2 × 0.1] seconds after detecting a slip.
• When either t1 or t2 is out of the specified range, this command is ignored and
the previously set value is not changed.
• In the following cases, the printer continues waiting for a slip to be inserted (until
the TOF sensor detects a paper present status).
① Waits for a slip to be inserted when a printing stop due to a paper-end is
enabled.
② Waits for a slip to be inserted when the printer recovers from an error.
• Using DLE ENQ 3 cancels the slip waiting state. The data in the receive buffer
and the print buffer are cleared in this time.
[Notes] • When the slip insertion wait time is set to be longer than the default value, a
problem such as a paper jam may occur. The default value for the slip insertion
wait time is recommended.
[Default] t1 = 0, t2 = 5