Specifications
Confidential
SHEET
135
NO.
SHEET
REVISION
I
TITLE
TM-H5000II
IIII
II series
Specification
(STANDARD)
NEXT
136
ESC c 3 n
[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
[Range] 0 ≤ n ≤ 255
[Description] Selects the paper sensor(s) to output paper end signals
• Each bit of n is used as follows:
Bit Off/On Hex Decimal Function
0 Off 00 0 Paper roll near-end sensor disabled.
On 01 1 Paper roll near-end sensor enabled.
1 Off 00 0 Paper roll near-end sensor disabled.
On 02 2 Paper roll near-end sensor enabled.
2 Off 00 0 Paper roll end sensor disabled.
On 04 4 Paper roll end sensor enabled.
3 Off 00 0 Paper roll end sensor disabled.
On 08 8 Paper roll end sensor enabled.
4 Off 00 0 TOF sensor disabled.
On 10 16 TOF sensor enabled.
5 Off 00 0 BOF sensor disabled.
On 20 32 BOF sensor enabled.
6, 7 - - - Undefined.
[Details] • It is possible to select multiple sensors to output signals. Then, if any of the
sensors detects a paper end, the paper end signal is output.
• The sensor is switched by executing this command. The paper end signal
switching be delayed, depending on the receive buffer state.
• If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper
sensor outputting paper-end signals.
• If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper
sensor outputting paper-end signals.
• When all the sensors are disabled, the paper end signal always outputs a paper
present status.
• The command is available only with a parallel interface and is ignored with a
serial interface.
[Default] When DIP switch 1-3 is Off: n = 15
When DIP switch 1-3 is On: n = 0
J