Specifications

Confidential
SHEET
114
NO.
SHEET
REVISION
I
TITLE
NEXT
115
TM-H5000II
IIII
II series
Specification
(STANDARD)
ESC = n
[Name] Set peripheral device
[Format] ASCII ESC = n
Hex 1B 3D n
Decimal 27 61 n
[Range] 1 ≤ n ≤ 3
[Description] Selects device to which host computer sends data, using n as follows:
Bit Off/On Hex Decimal Function
0 Off 00 0 Printer disabled.
On 01 1 Printer enabled.
1 Off 00 0 Customer display disabled.
On 02 2 Customer display enabled.
2-7 - - - Undefined.
[Details] • When the printer is disabled, it ignores all data except for error-recovery
commands (DLE ENQ 1, DLE ENQ 2, DLE EOT, DLE EOT BS, DLE ENQ, and
DLE DC4) until it is enabled by this command.
[Default] Serial interface specification
• When turning on the printer:
Direct Connection Customer Display Status
n
Customer display is recognized (*1) 2
Customer display is not recognized (*1) 1
• When executing ESC @:
Default values set by ESC @ are as follows, depending on the value set by ESC
= just before processing ESC @ and on the setting of DIP switch 2-2:
Direct Connection Customer Display Status
n
Default Value to be Set
1 2 3
After ESC @
When customer display is connected (*1) 1 2 (*2) 2
Processing
When customer display is not connected (*1) 1 2 (*2) 1
(*1) Depending on the setting of DIP switch 2-2.
(*2) The printer is disabled and it does not process ESC @; therefore, the ESC =
setting is changed.
Parallel interface specification: n = 1
[Reference] DLE ENQ