Specifications

Confidential
SHEET
99
NO.
SHEET
REVISION
I
TITLE
NEXT
100
TM-H5000II
IIII
II series
Specification
(STANDARD)
DLE ENQ n
[Name] Real-time request to printer
[Format] ASCII DLE ENQ n
Hex 10 05 n
Decimal 16 5 n
[Range] 1 ≤ n ≤ 3
[Description] Responds to a request from the host computer. n specifies the requests as follows:
n
Request
1 Recovers from an error and restarts printing from the line where the error occurred
2 Recovers from an error after clearing the receive and print buffers
3 Cancels the slip waiting status
[Details] • The printer starts processing data upon receiving this command.
• This command is executed even when the printer is offline, the receive buffer is
full, or there is an error status with a serial interface model.
• With a parallel interface model, this command cannot be executed when the
printer is busy. This command is executed even when the printer is offline or
there is an error status when DIP switch 2-1 is on with a parallel interface model.
• DLE ENQ 1 starts printing from the line where an error occurred. This command
is available only for errors that have the possibility of recovery, except print head
temperature error.
• When the printer recovers from an error using DLE ENQ 1, and slip paper is
selected, the printer ejects the slip completely and loads paper. However, the
printer only ejects the slip and does not load paper when the printer recovers
from a slip ejection error.
• DLE ENQ 2 enables the printer to recover from an error after clearing the data in
the receive buffer and the print buffer. The printer retains the settings (by ESC !,
ESC 3, etc.) that were in effect when the error occurred. The printer can be
initialized completely by using this command and ESC @. This command is
enabled only for errors that have the possibility of recovery, except for print head
temperature error.
• When the printer recovers from an error using DLE ENQ 2 with slip selected, the
printer ejects the slip completely and selects the paper roll. Therefore, when
printing on slip is to be continued, select slip mode again using
ESC c 0 4 after the slip is ejected.