User`s manual
Table Of Contents
- Standards and Approvals
- Safety Precautions
- Caution Label
- Restriction of Use
- Downloading Drivers, Utilities, and Manuals
- Unpacking
- Part Names
- Setup
- Installing the Printer
- Connecting the AC Cable
- Installing/Replacing the Ink Cartridge
- Installing Paper
- Attaching/Adjusting the Paper Ejection Tray
- Installing the Driver and Connecting to the Computer
- Displaying the Printer Driver
- Setting DIP Switches
- Cleaning the Autocutter
- Head Cleaning
- Troubleshooting
- Operating Environment
- Specification
12 TM-C3400A User’s Manual
2. When you change the paper type, open the roll paper cover and
the fanfold paper cover to remove the paper.
3. Close the roll paper cover and the fanfold paper cover.
Removing roll paper
1. Pull the release lever to open the roll paper cover, and remove the
roll paper or used roll paper core.
2. Close the roll paper cover.
➁ Setting paper position detection
When paper position detection setting does not need to be changed,
skip this step. Use the printer driver for this setting.
1. Turn on the printer.
2. Change [Paper Position Detection] on the [Maintenance And
Utilities
] tab of the printer driver depending on the paper to use.
Note:
For information on how to display the printer driver, see page 19.
3. Turn off the printer.
CAUTION:
The changed setting of the paper position detection is stored in the
printer when the printer is turned off. Be sure to turn off the printer to
enable the setting.