User`s manual
Table Of Contents
- Standards and Approvals
- Safety Precautions
- Caution Label
- Restriction of Use
- Downloading Drivers, Utilities, and Manuals
- Unpacking
- Part Names
- Setup
- Installing the Printer
- Connecting the AC Cable
- Installing/Replacing the Ink Cartridge
- Installing Paper
- Attaching/Adjusting the Paper Ejection Tray
- Installing the Driver and Connecting to the Computer
- Displaying the Printer Driver
- Setting DIP Switches
- Cleaning the Autocutter
- Head Cleaning
- Troubleshooting
- Operating Environment
- Specification
10 TM-C3400A User’s Manual
Installing Paper
CAUTION:
When using this printer for the first time, be sure to install fanfold paper. If
you install the roll paper first, the printer will not start ink charging.
To change the paper type, be sure to change the setting of DIP switch
3 (Paper selection) before installing the paper.
Do not tilt the printer with the roll paper cover open. The roll paper
cover may close unexpectedly, and your fingers may be caught.
Make sure paper is ejected straight from the paper ejection guides, as
shown in the illustration. If paper is not ejected straight due to such
causes as an obstruction, the print result may be distorted.
Follow the steps below to install the paper.
❏ When using this printert for the first time:
“When installing fanfold paper” ➃ ➄, and after ink charging, go
to
➁.
❏ When you have used up the paper (when you install same type of
paper):
➀ and ➄
❏ When you change the paper type: ➀ ➄