Product specifications
Table Of Contents
- Cover
- For Safety
- About this Manual
- Contents
- Chapter1 Overview and Basic Operations
- Chapter2 Setup
- Chapter3 Preinstalled OS Information
- Chapter4 Utility
- Chapter5 Setting the Printer Driver
- Chapter6 Application Development Information
- Chapter7 Maintenance
- Appendix
36
Installing the Printer
Install the product at an appropriate place, leaving enough space around the product.
If you install the product against a wall, keep the rear and sides of the product more than 10 cm from
the wall.
Installation
• Leave enough space for the roll paper cover, ink cartridge cover, and fanfold paper cover to be fully
opened.
• Protect the product from heavy impacts. They may cause defective print.
• Do not allow cables to catch or foreign matter to accumulate under the product.
WARNING
Do not block the air vents on this product.
Blocking the air vents may result in internal heat build-up and fire.
CAUTION
Install the product horizontally on a flat, stable, and vibration-free surface.
Otherwise, the roll paper cover may not operate correctly, and your fingers may be
caught.
Do not tilt the product with the roll paper cover open.
The roll paper cover may close unexpectedly, and your fingers may be caught.
When carrying the product, be sure to hold the parts as shown in the picture below.
10cm
10cm
Air vents
Located on the left,
right, and back.