Product specifications
Table Of Contents
- Cover
- For Safety
- About this Manual
- Contents
- Chapter1 Overview and Basic Operations
- Chapter2 Setup
- Chapter3 Preinstalled OS Information
- Chapter4 Utility
- Chapter5 Setting the Printer Driver
- Chapter6 Application Development Information
- Chapter7 Maintenance
- Appendix
Chapter 5 Setting the Printer Driver
121
5
Setting the Post-Printing Movements
The following post-printing movement can be set on this printer.
Sets from [Settings For Handing Paper After Print] on [General] of the printer driver.
❏ Auto Cut: After Every Page/Only After Last Page/After Specified Number of Pages
After printing, the paper is fed to the position where autocutting is possible and feeding stops after
autocutting. When resuming printing, the paper is fed in the reverse direction to the printing position
and then printing resumes.
❏ No Auto Cut
•Feed To Peel Off Position
After printing, the printer stops without feeding paper. When the printer does not receive the next
print data for 1 second or more, the paper is fed to the position where autocutting is possible but
does not perform autocut. To cut the paper, press the CUT button. For the next print data, the
paper is fed in the reverse direction to the printing position, and printing resumes. When you want
to set no auto cut, this setting is recommended.
The difference from “Feed To Cut Position” is that when printing multiple data continuously, printing
takes less time with this setting. When “Feed To Cut Position” is selected, printing takes longer since
the paper is fed to the position where autocutting is possible and fed in the reverse direction to
the printing position for each job, even for continuous printing.
• Feed To Cut Position
After printing, the paper is fed to the position where autocutting is possible but does not perform
autocut. In this case, paper cutting is possible with the CUT button. When resuming printing, the
paper is fed in the reverse direction to the printing position then printing resumes.
• Stop at the Print End Position
This is the setting for Die-cut Label. After printing, the Die-cut Label is fed to the position where
peeling is possible and stop feeding.
Although autocutting is not performed, paper cutting is possible with the CUT button. When
resuming printing, the paper is fed in the reverse direction to the print starting position and then
printing resumes.