Installation manual

3-8 Utilities Rev. F
Starting and stopping the EPSON Status Viewer
During the driver installation operation, if the startup type is set to “Automatic” on the startup
type setting screen, the EPSON Status Viewer starts monitoring the printer as soon as the install
operation is completed. If you want to stop or start the EPSON Status Viewer again, use the
following procedure.
Note:
Before using StatusAPI, you need to stop the EPSON Status Viewer. For information on StatusAPI, refer
to the “StatusAPI Reference Manual.”
1. Open the [Control Panel] folder and then the [Administrative Tools] folder. Finally, select
[Services].
2. Select “EPSON Status Viewer Service” as shown below.
3. To stop EPSON Status Viewer:Right-click and then select [Stop] from the shortcut menu.
To start EPSON Status Viewer again:Right-click and then select [Start] from the shortcut
menu.
Note:
While the EPSON Status Viewer is stopped temporarily, if you turn the power of the printer off and
then on again or if you restart the computer, the EPSON Status Viewer starts again automatically.