Installation manual

2-8 Configuring Printer Driver Settings Rev. F
❏ If the set paper size/page size (“Paper Size/Page Size” on page 2-8) is larger than the printable area of
the paper source you have selected, the following message appears. Clicking [OK] displays the paper
settings screen (see “Paper settings screen” on page 2-9).
Auto Cut
The auto sheet cutter setting is available for selection, as shown below, only when the paper
source (see “Paper Source” on page 2-7) is set to “Roll Paper Holder.”
• Full Cut: Cut paper from edge to edge after printing is finished.
• None: Do not perform auto cut.
Paper Size/Page Size
Select a paper size or a page size to use from the list. Depending on the paper source (see “Paper
Source” on page 2-7), the paper sizes available from the list are different.
❏ If the paper source is “Auto Sheet Feeder,” the following paper sizes are available.
• Post Card 100 × 148 mm
• A6 105 × 148 mm
• Business Card 55 × 90 mm
• Refill (Bible Size) 95 × 170 mm
•User Defined Size
❏ If the paper source is “Roll Paper Holder,” the following page sizes are available.
• Roll Paper 76 × 297 mm
• Roll Paper 105 × 297 mm
•User Defined Size
❏ If the paper source is “Manual Feed Slot,” the following paper sizes are available.
• Post Card 100 × 148 mm
• A6 105 × 148 mm
• Refill (Bible Size) 95 × 170 mm
•User Defined Size
Note:
❏ For information on how to specify a user defined size, see “Specifying a user defined paper size” on
page 2-9.
❏ If you have selected a paper size/page size that is larger than the printable area in the paper source
setting (see “Paper Source” on page 2-7), the paper settings screen (see “Paper settings screen” on
page 2-9) appears.