Installation manual

Rev. F Configuring Printer Driver Settings 2-7
TM-C100 Printer Driver Operation Manual
Paper Settings
Use the [Paper] tab to specify the Paper Source, Auto Cut, Paper Size/Page Size, Copies,
Orientation, and Printable Area or Roll Paper Option.
Paper Source
The paper source setting differs depending on the paper source option setting on the [Option]
tab. (See “Paper Source Option” on page 2-3.)
❏ If the paper source option is set to “Auto Sheet Feeder”
Specify either “Auto-Sheet Feeder” or “Manual Feed Slot.”
❏ If the paper option is set to “Roll Paper Holder”
The paper source is set to “Roll Paper Holder” and cannot be changed.
❏ If the paper source option is set to “None”
The paper source is set to “Manual Feed Slot” and cannot be changed.
Note:
❏ To set the paper source, it is recommended that you start from the “Printers” folder. If you set the
paper source from an application, for example, this may cause incorrect print results.
❏ If the correct paper sources for the paper source option of your printer are not displayed, the paper
source option setting on the [Option settings] tab is incorrect. Set it correctly, referring to “Paper
Source” on page 2-7, and then select the paper source.