Material Safety Data Sheet

Version 3.9 (USA)
SDS T220XL420 3 Release Date 3/1/14
7.2
7.3
Recommendations :
Occupation hygiene :
Safe storage :
Specific end uses:
Keep out of reach of children and do not drink ink.
Do not dismantle cartridge.
Avoid contact with skin, eyes, and clothing.
In the case of skin contact, wash with soap and water.
Do not store cartridges in high or freezing temperatures.
Keep cartridges out of direct sunlight.
Do not store cartridges with oxidizing agents or explosives.
Make sure cartridges are dry before insertion into printer housing.
Not specified
Section 8 : Exposure controls / personnel protection
8.1
8.2
Control parameters :
Exposure controls
Engineering controls :
Personal protection :
Glycerols (CAS No. 56-81-5)
ACGIH TLV-TWA 8-hour Exposure Limit is 10 mg/m
3
as glycerin mist.
OSHA Z-1 PEL is 5 mg/m
3
as glycerin mist, respirable fraction.
OSHA Z-1 PEL is 15 mg/m
3
as glycerin mist, total dust.
Proper ventilation
Personal protective equipment is not required under suitable use.
If there is a possibility of ink exposure, wear protective gloves, clothing, eye,
and face protection.
Respiratory protection is not required under suitable use.
Thermal hazards are not known under suitable use.
Environmental exposure
controls : Not established
Section 9 : Physical and chemical properties
9.1 Physical and chemical properties
Appearance :
Odor :
Odor threshold :
pH :
Melting point :
Freezing point :
Initial boiling point :
Boiling range :
Flash point :
Evaporation rate :
Flammability(solid/gas):
Upper/lower
Yellow liquid
Slight
No data available
9.0 - 10.0
Less than 0°C
Less than 0°C
Greater than 100°C
Greater than 100°C
Greater than 110°C (closed cup, ASTM D3278)
No data available
Not applicable (liquid)
flammability:
No data available
Upper/lower
explosive limits :
Vapor pressure :
Vapor density :
No data available
No data available
Greater than 1 (air = 1)