Operation Manual

To ensure that the document is not fed on an

angle, we recommend inserting the long side of

the document.

With the side of the document to be read facing

up, align the right edge of the document with the

loading guide.

Insert the document horizontally so that the

entire edge touches all inner rollers.

If the edge touches the roller, the document is fed

to the read start position automatically. After

automatic loading starts, release your hand and

do not obstruct the loading of the document.

After the document has been loaded, remove the

loading guide, and then make sure the left edge of

the document and the guide line are aligned.

If the document is copied or scanned with the

loading guide still attached, the edge of the

document may be damaged.

Important:

If the document slants greatly from the guide

line, the slanted and protruding section is not

copied or scanned. Press the r button to eject

the document, and then reload the document.

Note:

If the document is 1 m or longer, support it with

your hands so that it does not slant during reading.

How to change the document

eject direction and scanning

accuracy

The procedure to change the document eject direction

and to change to a higher scanning accuracy is described

below.

Note:

If you change the document eject direction to backward,

attach the paper eject guides before use. If the document

is ejected backward while the paper eject guides are not

installed, the document may be damaged if it falls to the

back and gets dirty or creased.

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide

Copying and Scanning