Operation Manual

Item Description
Save To HDD
Print And Save
*
Set whether or not to save print jobs in the optional hard disk unit
or Adobe PostScript 3 Expansion Unit.
By saving print jobs, you can print jobs directly from the hard disk
and check the print job information and status.
U “Saving to and Reprinting on the Optional Hard Disk Unit” on
page 69
If you select Print Only, print jobs are not saved.
Print Only
Printer Status
Item Description
Firmware Version xxxxxxx,x.xx,xxxx You can see the firmware version.
When an optional auto take-up reel unit is connected, its firmware
version is displayed below the firmware version of the printer.
Furthermore, when an optional Adobe PostScript 3 Expansion
Unit is connected, its two control versions are displayed at the end.
Option Status Lists the optional accessories currently connected to the printer and available for use.
Show Total Prints
XXXXXX m
2
Displays the total area of media printed (to a maximum of six
digits).
Print Status Sheet Press the Z button to print a list of current printer settings.
Choose this option to view settings at a glance.
Network Setup
Item Description
IP Address Setting
Auto
*
Select whether to use DHCP to set the IP address (Auto), or to set
the address manually (Panel). Set the IP address, Subnet Mask,
and Default Gateway on the Panel. Contact your system
administrator for detailed information.
Panel
IPv6 Setting Enable Select whether to enable or disable the IPv6 function.
Disable
*
IPsec Setting Enable Select whether to enable or disable the IPsec function.
Disable
*
PSK Setting Enter a Pre-Shared Key of up to 20 characters (half-width alphanumeric characters and symbols).
IEEE802.1x Setting Enable Select whether to enable or disable the IEEE802.1X function.
Disable
*
HTTPS Redirect Setting Enable Select whether to enable or disable the function to auto-direct
HTTP to HTTPS.
Disable
*
SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Using the Control Panel Menu
169