Operation Manual

Item Description
Add Margins
The position at which the margin is added depends on the Output
Size setting, as shown below.
❏ When set to Auto
The result is the same as when Standard is selected.
❏ When set to a standard size or User Defined
Adds 3 mm of margin (area of
in the following illustration)
outside the size selected for Output Size (area of
in the
following illustration). Actual output size becomes larger
than the selected size (area of
in the following
illustration) due to addition of the margins.
When the created data size does not fit in the output size, data
is reduced before printing.
SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Using the Control Panel Menu
166