Operation Manual

:The Large Copy Tab
This tab is displayed only when the optional
MFP scanner is installed.
In this tab, select a job you want to do, and then
press the Z button. When the optional hard
disk unit or Adobe PostScript 3 Expansion
Unit is installed, you can also use the scan
function.
U “Large Copying and Large Scanning using
the MFP Scanner (Option)” on page 73
, : The Print Queues Tab
Print job information appears in the info
display area.
When you press the Menu button, the Print
Queues menu appears.
U “Print Queues menu” on page 147
The Info Display Area
The name of the job being printed appears
when the printer driver is used.
If an optional hard disk unit or Adobe
PostScript 3 Expansion Unit is installed, it also
shows the number of held jobs, if any.
c
Important:
A flashing , icon indicates that an optional
hard disk unit or Adobe PostScript 3
Expansion Unit is transmitting data to the
printer. Do not disconnect the power cord or
turn the printer off while the icon is flashing.
Failure to observe this precaution could
corrupt the data on the hard disk unit or
Adobe PostScript 3 Expansion Unit.
. :The Paper Tab
The information of loaded paper appears in
the info display area.
When you press the Menu button, the Paper
menu appears.
U “Paper menu” on page 149
The Info Display Area
Displays the Source and Media Type of the
loaded paper.
When roll paper is used, it also shows the roll
width. When Roll Paper Remaining is On, it
shows the amount of roll paper remaining.
When the length remaining reaches or falls
below the value selected for Remaining Alert,
a
icon appears above the tab icon and an
alert like that shown below is displayed to warn
that the printer is nearing the end of the roll.
When roll paper is loaded on Roll 1/Roll 2 of
the SC-T7200D Series/SC-T5200D Series, you
can check which is selected (in use) by looking
at the icon.
: Indicates a roll that is selected (in
use).
The number indicates either Roll 1
or Roll 2.
: Indicates a roll in a standby state.
If there is an automatic switching
command, this roll is selected for
printing.
Automatic switching of roll paperU
“Switching Roll Paper Automatically before
Printing (SC-T7200D Series/SC-T5200D Ser‐
ies Only)” on page 97
SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Introduction
16