User`s guide

Basic Operations 75
9. Using a ruler that shows millimeters, measure the distance between the “+” symbols.
Record either the distance between the two center symbols or the average of the
distances between the left, center, and right symbols.
10.Pattern length is displayed in the control panel. Using the d/u buttons, enter the value
recorded in step 10 and press the Z button.
Performing Feed Adjustment During Printing
Feed adjustment during printing is recommended for minor banding issues.
1. Press the button during printing.
Note:
To rewind the media, press the u button. Stop rewinding before the media is past the
cutter groove (on the pressure roller side).
If the leading edge of the media is curled, stop rewinding before the media reaches the
inner side of the front cover.