User`s guide

Basic Operations 63
When the Standard Auto Take-up Reel Unit Is Installed
This section describes how to remove media from the take-up reel.
1. Cut the media and roll the cut end onto the take-up reel. See “Cutting Media” on page
50.
2. To prevent the media from sliding off the roll, support the roll at its left end.
3. Loosen the left roll core holder fixing screw and remove the roll core holder from the roll.
4. Lower the roll onto the roll support.
5. To prevent the media from sliding off the roll, support the roll at its right end.
c
Caution:
❏ Because the media is heavy, it should not be carried by one person. When loading or
removing the media, use at least two persons.
❏ Perform the following procedure to properly remove the take-up roll. Injury may occur
if the take-up roll falls.