User`s guide

Appendix 131
Moving and Transporting the Printer
This section describes how to move and transport the product.
Moving the Printer
This section assumes that the product is being moved to another location on the same floor
without traversing stairs, ramps, or lifts. See below for information on moving the printer
between floors or to another building. See “Transport” on page 132.
Getting Ready
1. Confirm that the printer is off.
2. Remove the waste ink bottle. See “Replacing the Waste Ink Bottle” on page 94.
3. Disconnect the power cords and all other cables.
4. Remove media from the media feeding unit and auto take-up reel unit.
5. Unlock the stand.
Release the caster locks on the left and right legs and fully raise the adjusters.
6. Move the printer.
c
Caution:
Do not tilt the product more than 10 degrees forward or back while moving it. Failure to
observe this precaution could result in the printer falling over, causing accidents.