User`s guide

Using the Control Panel Menu 113
1 to 30 (media setting bank number)
Tension Measurement Periodically Choose Periodically or Every page to have the printer automatically
monitor and adjust media tension during printing for optimal results, Off
to disable automatic tension adjustment.
Periodically is recommended in most circumstances.
The printer may however be unable to adjust tension appropriately for
some media, resulting in excessive slack or other maladjustments that
cause printing problems, in which case you should select Off. Note,
however, that Off may result in unusually large margin between pages.
In addition, printing may not stop and the inside of the printer may
become stained. Observe the following precautions:
Do not print at the end of a roll.
Do not select Off for Media End Check.
Select Every page for more precise tensioning, but note that print times
will increase.
Every page
Off
Media Tension 0 to 40 Increase tension if creases appear in media during printing. The higher
the value, the greater the tension.
The manufacturer default set values will change as follows depending on
the Tension Measurement setting.
Periodically/Every Page: Level 28
Off: Level 39
Item Parameter Explanation
Setting Name Assign the media setting bank a name up to 22 half-size characters long.
Using distinctive names makes it easier to select banks for use.
Feed Adjustment Manual Use this option if banding (horizontal banding, lines, or strips of uneven
color) persists after head cleaning and head alignment have been
performed.
Visually inspect the printed pattern and enter the adjustment value by
hand. See “Feed Adjustment” on page 73.
Platen Gap
1.5 Choose the platen gap (the distance between the print head and the
media).
The default setting of 1.5 is recommended in most situations. Choose 2.0
if printout is scratched or smudged. Select 2.5 only if print results are still
smudged when 2.0 is selected. Choosing a larger gap than required may
result in ink stains inside the printer, reduced print quality, or shorter
product life.
2.0
2.5
Head Alignment Manual(Uni-D) Select Head Alignment to align print head when print results seem
grainy or out of focus.
You need to check the pattern and enter the optimum adjustment value
for alignment. See “Correcting Print Misalignment (Head Alignment)” on
page 71.
Manual(Bi-D)
Drying
Item Parameter Explanation