User`s manual

87
Version 1.1 Revised February, 2009
Chapter 8 - FastRIP Print Options
2. Select Yes to “Do you want to create a Underbase from the transparency layer”.
NOTE: If you do not need an Underbase or do not care about the extra options, you can leave this as No and set
the job up as if the file were a non-transparent image.
Select the 3. Underbase Print Mode and other options.
se l e c t PR I n t mo d e
Consult your Printer Manual for information on Underbase Print Modes.
un d e R B a s e st R e n g t h :
is has 4 settings for determining the Underbase to be created.
None ` : Doesn’t create an Underbase, would only typically be used if you
just wanted a highlight white on the image
Minimum ` : Converts the transparency information to an Underbase and
then process’s the Underbase to remove areas of the Underbase were the
colors in the main image are black (as you do not need to print white
under black).