User`s manual

77
FastRIP 10.0 User’s Manual
Version 1.1 Revised February, 2009
Ch a P T e r 8
FastRIP Print
Options
Introduction
FastRIP has many different options that you can enable and control. is chapter will cover the
basic controls and options features of FastRIP 10.0.
NOTE: If you always rely on your graphics application to open FastRIP you may experience occasional errors or
output issues. For that reason, we recommend you open FastRIP before sending a Print command from your graphics
application.
Print Controls
st a R t I n g a n d st o P P I n g PR I n t jo B s
When print jobs are received by FastRIP, they can be either printed immediately, or they can be
collected for later printing. e main controls for controlling print jobs are the Start Queue and
Stop Queue buttons (available from the FastRIP toolbar). e Start Queue and Stop Queue
commands are also available under the Queue menu.
If the Start Queue button has been clicked, then print jobs will be printed immediately. If the
Stop Queue button has been clicked, then print jobs will be held until manually released.
A held job can be printed by right-clicking the job and choosing Print from the context-menu.
Alternatively, select the job and choose Print from the Jobs menu.
In addition to the Start Queue and Stop Queue buttons, the scheduling settings also control
whether a job is printed or held. e scheduling controls are set via Queue menu >> Properties
>> Layout Manager tab.