User`s manual

137
Version 1.1 Revised February, 2009
Chapter 10 - Output Settings
Use Printer’s Default Screen = OFF (unchecked) `
It is recommended that you uncheck the Use Printer’s Default Screen
option. Doing so will enable the Halftone Screen controls and sets cus-
tom halftone settings for the print. Refer to the PhotoShop help file for
an explanation of these controls.
Use Printer’s Default Screen = ON (checked) `
Enabling this option will cause FastRIP to use the halftone information
from the print mode.
Click 12. OK to close the Halftone Screen dialog.
Click the 13. Print button to proceed.
se P a R a t I o n s I n co R e l dR a W ®
e following procedure was written using CorelDraw X3. For other versions of CorelDraw,
please refer to the CorelDraw help file or documentation.
From the 1. File menu, choose Print.
e 2. Print dialog will open.
Click the 3. Separations tab.
Tick the 4. Print separations checkbox.
Beside each color channel is a checkbox. Tick the channels that should be printed 5.
as separations.
e 6. Use advanced settings checkbox determines how halftones will be applied, as
follows:
Use advanced settings = ON (ticked) `
(Recommended) is enables custom halftone settings that can be adjusted by clicking the
Advanced button. Refer to the CorelDraw help file for an explanation of these controls.
Use advanced settings = OFF (unchecked) `
is will cause FastRIP to use the halftone information from the print mode.
Once the 7. Print dialog settings are ready, click the Print button to print the sepa-
rations to FastRIP.