User`s manual

Chapter 9 - Print Modes and Printer Information
122
FastRIP 10.0 User’s Manual
FastRIP 1440 SD at 45 LPI
FastRIP 1440 SD at 55 LPI
FastRIP 1440 SD at 65 LPI - Use this mode for most output, including
clear film that is smooth and waterproof inkjet film. is option may ex-
perience more banding or streaking when used on poor quality film that
has a rough surface. is is the default for Current Settings.
High Speed Output Print Modes `
FastRIP 720 SD HS at 45 LPI
FastRIP 720 SD HS at 55 LPI
FastRIP 720 SD HS at 65 LPI
FastRIP 1440 SD HS at 45 LPI
FastRIP 1440 SD HS at 55 LPI
FastRIP 1440 SD HS at 65 LPI
pr O O F a n d He a t tr a n S F e r ` PR I n t mo d e s
FastRIP does not support Print Modes for Heat Transfer or color Proofs
on the Epson 4800 or 4880. Please check our website: www.screenprint-
ers.net for updates.
ep S O n 4800 a n d 4880 Hi n t a n d ti p S
Service Req. error 00010007-is occurs when the Green tab becomes `
locked on the head of the printer. Lift the top lid of the Epson 4800 and
locate the head of the printer and its bright green tab. Pull this green tab
out. Turn the printer OFF then back ON.
Film curl - If the film curls up, toward the ceiling, the Epson 4800 printer `
will have a difficult time recognizing the film. It helps to have the film lay
flat or curl down, toward the floor. FastPOSITIVE has the correct curl.
To Remove Jam or Reload film - On the rear of the printer is the Roller `
Release Lever. Pull the lever back, away from the printer. Now you pull
out the film or straighten it. Once the jam is cleared or the paper is re-
loaded, push the Release Lever forward.
Reset - Sometimes it may be necessary to reset the printer. To do this, `
hold down the Pause button for 3 seconds.
Clear horizontal lines through the image - If you have clear horizontal `
lines running through the image, a head cleaning will need to be per-
formed. A general head cleaning can be done through the regular Epson
driver. Resolving this issue may require up to 10 Head Cleaning cycles. If