User`s manual

Chapter 9 - Print Modes and Printer Information
116
FastRIP 10.0 User’s Manual
age Printers. Select the Epson 2200 printer. Change the port to match the one to which the Epson
printer is connected. If you are using a USB cable, the correct port would be Epson Stylus Photo
2200_USB00*. If you are connected via a Parallel cable, it would be will be LPT*. Click on Ok
and try to print again.
If the Green light (Power button) is blinking and nothing prints:
Ensure no ink cartridge lights are indicating an”empty’ status on the printer. All empty ink car-
tridges need to be replaced before printing.
Open FastRIP and check the status of the job.”Holding”,”Pending”, or”Holding with Error”. If
listed as Holding or Pending, right-click on the job and select Print. If the job is listed as Holding
with Error, right-click on the job and select Remove. Go to Printers/Manage Printers and ensure
the correct port is being listed for connecting the printer and computer. Try printing the job
again.
If the image prints outside the page border or is cut off:
Make sure that you have the Page Size set correctly within your application.
eP s o n 4000
e Epson Stylus 4000 is a Professional Wide Format printer. Before configuring FastRIP, read
the Epson Stylus Pro 4000 User’s Guide for Print Head alignment, paper loading and printer
management instructions.
FastRIP PRO version 10.0 for the Epson 4000 supports:
PostScript Level 3 Images `
Printing images up to 17” in width and length `
Left and Right borderless bleed printing on certain page sizes `