User`s manual

115
Version 1.1 Revised February, 2009
Chapter 9 - Print Modes and Printer Information
ep S O n 2200 pr i n t e r ti p S
Execute a Head Cleaning cycle on your printer each morning. `
If streaking occurs, do a Nozzle Check, Head Alignment and Head `
Cleaning from the standard Epson printer driver. You can perform up to
TEN head cleaning routines in succession. Select your EPSON Stylus
PHOTO 2200 printer and click on on Properties > Printing Preferences.
Select the Maintenance tab.
Cover your printer at night to prevent dirt and dust from fouling the `
Print Head.
Remove all ink cartridges before moving the printer to a new location. `
Hold down the ` Ink button to move the Print Head for ink cartridge
replacement.
mi S C e l l a n e O u S
For best results you must use FastPOSITIVE WP film with FastINK. `
Regular Epson UltraChrome ink will not work for printing film positives.
e imaging side of inkjet film is the sticky side if you touch it with a wet `
finger.
Fan the sheets of film before loading them in the paper tray. It is best to `
feed film sheets one at a time.
In high humidity conditions, do not stack output films before they are `
dry. You may use a hair dryer to speed the drying process.
To make imaged films water resistant on non-waterproof films, spray `
them with an Artist’s Fixative.
Handle film by the edges and store it in a cool, dry location. `
You may use a Film Opaque Pen to do minor touch-up work. `
tr O u b l e S H O O t i n g
If the printer will not print:
Make sure a job is not hung-up in FastRIP. You can check the status of a print job in FastRIP’s
Queue Window. If a print job is listed as”Pending”, go to the Queue menu and select Start.
e RIP or Printer Driver may not be set to correct port. Open FastRIP and go to Printers/Man-