User`s manual

113
Version 1.1 Revised February, 2009
Chapter 9 - Print Modes and Printer Information
FastRIP- Proof 65 LPI `
Paper proof at 65 LPI.
FastRIP- Generic Proof `
Print a color calibrated Inkjet Paper proof. You can also use the standard
Epson driver for this.
uS i n g a bu l k in k Sy S t e m W i t H t H e ep S O n 2200
A Bulk Ink System comes in the form of easy-to-use 90 ml. bags for continuous flow printing. To
get the best performance from your Bulk Ink System:
Replace all of color the cartridges with special ”always read full” bulk `
cartridges.
Conserve ink by keeping the printer ON when not in use. When the `
printer powers ON or when it’s performs a Head Cleaning cycle, it uses
ink to prime the Print Head. (Always have extra cartridges available in
case you run out of any inks.)
Keep the ink bag at the proper height. When mounted correctly, the `
supply tube attached to the bulk bag should be about 2” above the print
surface.
in S t a l l i n g Fa S t ink i n yO u r pr i n t e r
Open the output tray, the printer cover and the cartridge cover.1.
Shake each unopened cartridge 4 or 5 times. en remove them from their pack-2.
ages. (Don’t shake them after removing the packaging)
Slide each FastINK cartridge into the appropriate slot with the green circuit board 3.
facing the back.
Gently press down on the cartridge until it clicks into place.4.
Close the cartridge cover and printer cover.5.
Press the ink button. e green power and red ink lights will flash for about 90 6.
seconds as your printer charges its Print Head with the new ink.