User`s manual
109
Version 1.1 Revised February, 2009
Chapter 9 - Print Modes and Printer Information
Here are some tips to help the Epson 3000 or Epson 1520 recognize film transparencies.
Place additional sheets of film in the printer. For example, if you are `
printing a 6 color separation, put 8 sheets of film in the printer. Some-
times, if the film has built up a charge of static electrify, the printer may
feed 2 sheets of film at a time. Shuffle and fan the film to reduce any
static electrify.
Place regular white paper beneath the sheets of film. is allows the Ep- `
son printer to recognize and feed the film.
If the problem persists, dust or debris may be covering the sensor. Run a `
cleaning sheet through the printer. Cleaning sheets can be found at local
computer stores.
Place the film in the paper tray and send a print job. Hold on to the film `
and let the printer try to grab it. When the printer tries to grab the film a
second time, release the sheet and the printer should feed the film.
ep S O n St y l u S rip
e Epson Stylus RIP is designed exclusively for color management and does not have the capa-
bility to print halftone dots. e Epson Stylus RIP may also cause conflict with the FastRIP. DO
NOT install the Epson Stylus RIP. If the Epson Stylus Rip has been installed, you must un-
install the RIP before installing FastRIP.
pa p e r Se t t i n g S
Ensure the paper-release lever is set to”single sheet.” `
Set the paper thickness to 0. `
If using roll film, set your printer to ` Banner Mode. Refer to the Epson
User Guide for more details.