User`s manual

105
Version 1.1 Revised February, 2009
Chapter 9 - Print Modes and Printer Information
Triple Density `
1440 x 720 TD or 1440 x 1440 TD at 40 LPI
1440 x 720 TD or 1440 x 1440 TD at 60 LPI
1440 x 720 TD or 1440 x 1440 TD at 80 LPI
Hi g H Sp e e d Ou t p u t PR I n t mo d e s
FastRIP allows you to print twice as fast by selecting HS (High Speed) mode. In HS mode there
might be a slight decrease in the amount of ink laid down and there could be minor registration
issues on large prints.
High Speed Standard Density `
1440 x 720 SD HS or 1440 x 1440 SD HS at 40 LPI
1440 x 720 SD HS or 1440 x 1440 SD HS at 60 LPI
1440 x 720 SD HS or 1440 x 1440 SD HS at 80 LPI
High Speed Double Density `
1440 x 720 DD HS or 1440 x 1440 DD HS at 40 LPI
1440 x 720 DD HS or 1440 x 1440 DD HS at 60 LPI
1440 x 720 DD HS or 1440 x 1440 DD HS at 80 LPI
High Speed Triple Density `
1440 x 720 TD HS or 1440 x 1440 TD HS at 40 LPI
1440 x 720 TD HS or 1440 x 1440 TD HS at 60 LPI
1440 x 720 TD HS or 1440 x 1440 TD HS at 80 LPI
in S t a l l i n g Fa S t ink i n yO u r pr i n t e r
Open the output tray, the printer cover and the cartridge cover.1.
Shake each unopened cartridge 4 or 5 times. en remove them from their pack-2.
ages. (Don’t shake them after removing the packaging)
Slide each FastINK cartridge into the appropriate slot with the 3. Green circuit
board facing the back.
Gently press down on the cartridge until it clicks into place.4.
Close the cartridge cover and printer cover.5.
Press the 6. Ink button. e Green power and Red ink lights will flash for about 90
seconds as your printer charges its Print Head with the new ink.