User`s guide

Installing the StylusRIP Software
1-8
2. Click
Install. You see the Updater dialog box:
3. Make sure your printer model name appears in the
Printer
box. If it doesn’t appear, click the arrow in the box and
select it from the list. If you’re on a network and the printer
has a network interface installed, click
Net Scan so the
software can find it for you.
4. Select the printer connection. If you connected the printer
via a serial cable, select the printer or modem port. If you
connected the printer to a network card and use AppleTalk
zones, select the zone where it is located.
5. Click
Update. You see a dialog box asking you to confirm
the printer model. If it’s correct click
Install; if not, click
Stop and check your selections in steps 5 and 6. You see a
message telling you to turn off the printer.
install.fm5 Page 8 Thursday, June 5, 1997 10:49 AM