User`s guide

192
192 | Installing and Using Optional Equipment
Using the Auto Take-Up Reel
To install the Auto Take-Up Reel, follow the instructions in the manual that
came with it.
To use the paper guides packaged with the Auto Take-Up Reel, first remove
the paper guides and holders that came with the printer, if you installed
them. Then attach the paper guides packaged with the Auto Take-Up Reel.
The table below describes the status of the Auto Take-Up Reel as indicated
by the
Sensor light.
Sensor light status Description
On The Auto Take-Up Reel is ready to take in your printout.
Flashing The Auto Take-Up Reel sensor is not aligned; see
page 199 to adjust the sensor.
Flashing rapidly The Auto Take-Up Reel has an error and stopped
working; check the installation and see page 199 for
additional solutions.
Off The Auto Take-Up Reel is turned off.