User`s guide

165
Solving Problems | 165
COMMAND ERROR
CHECK DRIVER
SETTINGS
You may be using the wrong
printer driver.
Damaged data was sent to the
printer or the data has an
incorrect command.
Press and hold the Pause button for
3 seconds to cancel the print job. Make sure
you installed the correct driver for your printer.
The driver’s ink type
configuration is not correct for
the ink in the printer.
Make sure the ink configuration is correct (see
page 148).
CONVERSION CRTG LIFE
CONVERSION CRTG
NEAR END OF SERVICE
LIFE
The conversion cartridge will
need to be replaced soon.
(Remaining service life is
displayed on the LCD.)
Press the Pause button to continue.
CONVERSION CRTG LIFE
REPLACE CONVERSION
CRTG WITH A NEW ONE
The conversion cartridge needs
to be replaced.
Replace the conversion cartridge with a new
one. Or, complete the replacement of black ink
by pressing the Pause button.
COVER OPEN
CLOSE COVER
Front cover is open. Close the front cover.
F/W INSTALL ERROR
UPDATE FAILED
RESTART THE PRINTER
Firmware update failed. Restart the printer, then update the firmware
again; see page 42 for instructions.
INK CARTRIDGE
INSTALL INK CARTRIDGE
An ink lever is raised, but no
cartridge is installed.
Install the missing ink cartridge.
INK CARTRIDGE
NON-GENUINE
CARTRIDGE! MAY NOT
PERFORM AT OPTIMUM.
CONTINUE?
<YES NO>
A non-genuine ink cartridge is
installed.
Press the r button to select NO and replace
the ink cartridge with a genuine Epson ink
cartridge; see page 141. Otherwise, press l to
select YES.
INK CARTRIDGE
PLEASE USE GENUINE
EPSON INK CARTRIDGES
A non-genuine ink cartridge is
installed.
Replace the ink cartridge with a genuine Epson
ink cartridge; see page 141.
INK CARTRIDGE
REPLACE INK
CARTRIDGE
Ink cartridge(s) are expended
(printing stops).
Replace the ink cartridge(s) indicated on the
LCD display; see page 141.
Message Explanation Response