Specifications

Epson Stylus Pro 4880
12/07 7
Replacing an Ink Cartridge
The easiest way to check ink levels is from the control panel:
Tip: You can store partially used ink cartridges for up to 6 months.
When the red B ink light is flashing (and INK LOW is
displayed on the LCD panel), the indicated cartridge is almost
expended. Make sure you have a replacement cartridge. When
the light stays on and
REPLACE INK CRTG is displayed, the
cartridge is expended. You must replace the cartridge before
you can continue printing.
You can install any combination of 110 ml and 220 ml
cartridges. It’s a good idea to keep a set of expended 110 ml
cartridges on hand at all times in case you need to ship the
printer.
See page 3 for information on selecting the correct
replacement cartridges. Before you start, make sure the printer
is turned on. Then follow these steps to replace an ink
cartridge:
1. Note the color of the cartridge whose light is on or flashing.
This is the cartridge you need to replace.
Caution: Leave the expended cartridge in the printer until you
are ready to replace it. To prevent ink reporting errors, never
replace the ink cartridges with the printer turned off.
2. Press the ink compartment cover to open it.
3. Raise the ink lever to the unlocked position.
4. Remove the expended ink cartridge from the printer. Make
sure you save your first set of expended 110 ml cartridges so
you can use them for transporting the printer if necessary.
WARNING: Do not shake the expended cartridge, or ink may
leak out. If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets in your eyes, flush them immediately
with water.
5. Make sure the replacement cartridge is the correct color,
and remove it from its package.
6. Gently shake the cartridge before installing it.
1 2 3 4 5 6 7 8
Menu
3sec.
1
Matte
Black/
Photo
Black
2 Cyan
3 Vivid Magenta
4 Yellow
6 Light Cyan
8
Light
Light
Black
7 Vivid Light
Magenta
5 Light Black
Full
Expended