Specifications

Epson Stylus Pro 4880
12/07 5
NO BORDERLESS WITH THIS
SIZE
RELOAD PAPER
Note:
These messages alternate.
— Borderless setting is selected for
A2-size sheets (11.7 × 16.5)
Change the setting in the printer driver, or load
different-size paper.
NO INK CRTG B Ink light on Ink cartridge(s) not installed or ink
lever raised.
Install ink cartridges or lower the ink lever.
NO MNT TNK — The maintenance tank is not installed. Make sure the maintenance tank is fully inserted.
NOT STRAIGHT RELOAD Paper light on Cut sheet paper is not loaded straight. Load the paper correctly.
NOZZLES STILL CLOGGED — Head cleaning did not clear the
nozzles.
Run the head cleaning utility again.
PAPER NOT CUT Paper light
flashing
Roll paper was not cut correctly. The
cutter may be blunt or incorrectly
installed.
Open the top cover and remove the uncut paper.
Reload paper if necessary.
Reinstall or replace the cutter blade if necessary.
PAPER NOT STRAIGHT Paper light
flashing
The paper slipped and fed into the
printer at an angle or is loaded
incorrectly.
Reload paper, making sure the edges are straight.
PAPER OUT Paper light on No paper is loaded or the paper ran
out, or it is loaded incorrectly.
Remove any printouts or paper remaining in the printer
and load more paper correctly.
If the message appears during a print job, reset the
printer by pressing the pause button for 3 seconds.
Then load paper and resend the job.
PLEASE USE GENUINE EPSON
INK CARTRIDGES
— A non-genuine Epson ink cartridge is
installed.
Replace the ink cartridge with a genuine Epson ink
cartridge.
REAR COVER OPEN — The rear cover is open. Close the rear cover.
RELEASE LEVER
REMOVE PAPER JAM
Paper light
flashing
Paper has jammed in the printer. Remove the jammed paper. See the Printer Guide for
more information.
RELOAD PAPER Paper light on Printer cannot detect paper or the
PAPER NOT CUT error was cleared.
If you are using cut sheets, make sure the paper is flat.
Move the paper lever. Then reload paper.
RELOAD PAPER
INSERT DEEPLY
Paper light on Manually loaded sheet is not inserted
far enough.
Insert the sheet further into the printer.
REMOVE PAPER
Paper light on Paper is too thick for head cleaning. Remove the thick paper and move the paper lever out
to the secured position. Head cleaning automatically
starts. After cleaning, reload paper.
Printer could not feed the paper. Remove the paper.
REPLACE CNVRSION CRTG — The conversion cartridge needs to be
replaced.
Replace the conversion cartridge with a new one, or
complete the replacement of the black ink by pressing
the pause button.
REPLACE INK CRTG B Ink light on Ink cartridge is expended. Replace the expended ink cartridge with a new one.
SERVICE REQ. All lights flashing The print head is locked. Remove the protective materials and pull the green
tab on the left side of the print head to release the
print head.
An error has occurred. Turn the printer off and unplug the power cable. Let
the printer sit for a while, then try reconnecting the
power cable and turning the printer back on. If this
message appears on the LCD again, note the error
number and contact Epson.
SET INK CRTG — Ink cartridge chip error. Remove and reinstall the ink cartridge. If the message
remains, replace the cartridge.
Message/Light Light Explanation Response