Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Print Head Replacement Printer Component, Software Item, LCD Display, Printer Button Page 98.
21. Remove the Print Head Alignment Tension Spring.
21.1 Move the Print Head Alignment Lever (A13 Slant) to the right, to release pressure on the Spring.
21.2 Gently grab the Spring with a pair of needle nose pliers.
21.3 Pivot the bottom of the Print Head away from the Carriage Mechanism to release pressure on the Spring.
21.4 Remove the Spring, but leave the Print Head in the Carriage Mechanism.
View is from the floor looking
up at the Print Head
Spring
Pivot Print Head in this
direction to release the
spring.