Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Paper Loading Errors (Roll) Printer Component, Software Item, LCD Display, Printer Button Page 90.
9.2.6.1 Adjust VR3 (rough) and VR6(fine) adjustment pots within the range stated above.
10. Top Margin adjustment: Perform Top/Side and bottom margin adjustments.
10.1 Enter Self Diagnostics Mode by powering on the Printer while holding the Paper Source + Cut/Eject +
Paper Feed - buttons. The Display will indicate Check:Test
10.2 Load Roll Paper into the Printer.
10.3 Navigate to Check:Adjustment and press the Enter button. The display will indicate ADJ:Check Skew
10.4 Navigate to ADJ: Top & Bottom and press the Enter button. The display will indicate ENTER:PRINT
10.4.1 Press the Enter button to print the adjustment pattern.
10.4.2 Measure the distance from the leading edge, the side(closest to the home postion) and the bottom
and record the measurements. Input the measured values into the respective areas.
The required measurements are as follows: Top and Side = 3mm: Bottom = 14mm. Once the printed
pattern measures the above values, no adjustments are required.
10.4.1 The LCD should display RearAD: followed by xxx xxx xxx (Example: 07F 040 04E).
11. If the above symptoms still occur, perform the following Mechanical Adjustment for the Edge
Sensor and then repeat Step 3: Top Margin adjustment.
11.1 Ensure that the Edge sensor is installed correctly. refer to figures below. If any changes have been made to
the physical position of the sensor steps 1 and 2 must be performed.
Improper Installation
Adjustment Point
Correct Installation