Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Paper Loading Errors (Roll) Printer Component, Software Item, LCD Display, Printer Button Page 89.
7.1.2 Press the Paper Source button until the LCD Displays Sen: EdgeAD.
8. If the Edge AD Sensor does not react to media:
8.1 Re-seat the Print Head Foil Cables at both ends, that carry the signal to the Driver Board.
9. Edge Sensor adjustment:
9.1 Enter Self Diagnostics Mode by powering on the Printer while holding the Paper Source + Cut/Eject +
Paper Feed - buttons. The Display will indicate Check:Test
9.2 Press the Enter button once then navigate through the menus until the display indicates Test:Sensor.
9.2.3 Press the Enter button once then navigate to Sen:Edge AD xxx xxx.
9.2.4 Leaving the Front Cover open, Load plain photo copy paper into the Printer.
9.2.5 Release and move the print head over the paper and observe the changes to the Right Value
“XXX”
9.2.6 Confirm that the Right Value is within the range of 0C0 - 0CF with the Values.
Place a business card under
the Sensor.
Watch the 6 digits on the right side of the Control Panel
LCD. Remove the business card, and look for a significant
change in the 6 digits on the right side of the display.