Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Paper Loading Errors (Roll) Printer Component, Software Item, LCD Display, Printer Button Page 85.
Paper Loading Errors (Roll)
1. Verify media type and vendor.
1.1 Epson or Non-Epson media.
1.2 Verify the media characteristics.
1.2.1 Not too transparent.
1.2.1.1 Media that is too transparent may not be recognized by the Paper Sensors.
1.2.2 Not too thin.
1.2.2.1 Thin media may skew.
1.2.2.2 Thin media may crease.
1.2.2.3 Thin media requires a High Tension Spindle.
1.2.3 Not too thick.
1.2.3.1 Thick media may retain its curl and:
1.2.3.1.1 “Hang up” while inserting.
1.2.3.1.2 Strike the Print Head when the media’s width is being verified.
1.3 Measure the width of the media.
1.3.1 The media must be exactly one of the supported widths.
1.3.1.1 10”, 24”, 36”, 44”
1.3.2 A slight size variation (1/4”) could cause a Paper Loading Error.
1.4 Verify that there is no printing on either side of the media that could confuse the Edge Sensor, causing a
loading error.
1.5 Try a different media for contrast.
2. The Reload Paper error can be generated when a print job is sent:
2.6 If the image’s page size is larger than the loaded media.