Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Paper Feed Belt Tension Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 83.
Paper Feed Belt Tension Adjustment
Note: The following instructions are for the purpose of performing the belt tension adjustment when
the 4000g Tension Gauge is not available. Recommended tension is 3500g
1. Remove the Left Side Cover (7 Screws).
2. Loosen the 4 screws on the Fixing Bracket circled in FIG. 1.
3. Slide the Fixing Bracket in the direction indicated in FIG. 1.
4. While holding the Bracket in place, tighten the bottom left and top right screws to secure
Bracket evenly.
5. Secure remaining 2 screws.
6. Inspect the Belt tension by pressing with your finger as shown in FIG. 2.
7. The Belt will flex approximately a 1/8”. Refer to red circle in FIG. 2.
8.
NOTE: If the Paper Feed Timing belt tension is to loose, Horizontal Banding will appear. Refer to the
Image Quality Diagnosis Document for more details on Horizontal Banding.
Fig.1 Fig. 2