Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Missing Nozzle Diagnosis and Repair Printer Component, Software Item, LCD Display, Printer Button Page 79.
4.1.1 Replace the Cap Assembly and check for proper operation.
4.1.2 If the Cap Assembly does not repair the Printer, replace the Print Head.
4.2 If the ink flow is equal on all three tubes, and the related solenoids activate:
4.2.1 Replace the Driver Board.
All Nozzle Pairs Missing
1. Perform a cleaning cycle.
2. Determine whether the Waste Ink Tubes are passing ink. There should be and substantial volume
on all three tubes.
3. Determine whether all six Ink Cartridge Solenoids are activating to refill the sub tanks on the
Print Head. (It may take up to 4 cleaning cycles to activate a solenoid.)
4. If there is no or uneven ink flow on all three tubes, and the related solenoids do not activate:
4.2.1 Replace the Cap Assembly and check for proper operation.
4.2.2 If the Cap Assembly does not repair the Printer, replace the Print Head
4.2.3 If there is substantial ink flow on all three tubes, and the related solenoids activate
4.2.1 Replace the Driver Board.