Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Image Quality Diagnosis and Repair Printer Component, Software Item, LCD Display, Printer Button Page 70.
14. Replace the Paper Feed Motor (very rare)
Vertical Banding, Linear
1. Print with High Speed turned off (Uni-directional).
1.1 If the quality improves perform a Bi-directional adjustment.
2. Verify the Printer Driver settings.
Note: Non-Epson drivers may need to have a custom profile created to ensure optimum print quality.
Non-Epson drivers may not support MicroWeave. Use the Epson driver, supplied media, and image to
eliminate customer media, driver and application issues.
2.1 Set Resolution (1440 High Speed- OFF for best quality)
2.1.1 Slight banding may occur at lower resolutions. That is within the printer's specifications.
2.2 Verify that MicroWeave is enabled.
2.3 Verify Screening Method (Error Diffusion is the best choice).
2.4 Verify Paper settings.
2.4.1 Type (Plain, Semi-Gloss, Luster, etc.)
2.4.2 Configuration (Paper Thickness, Suction, etc.)
3. Perform the Head LR Adjustment
4. Verify Platen Gap, with the Printer Settings section, of the SelecType Menu.
4.1 Two settings are available: Standard and Wide.
4.2 Set to the appropriate setting to match the media (default is Standard)
4.3 Verify that the platen gap is being set to the proper position by observing the Platen Gap HP Flag.
4.3.1 Inspect Thickness Sensor Actuator for proper position.
4.3.2 Adjust if required.