Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Control Panel Map Page 7.
3. Check: Cleaning
6. Check: Life
4. Check: Print
5. Check: Parameter
1. [KK0] - Normal Cleaning Cycle is performed, volume of ink cleared = Low.
2. [KK1] - Strong Cleaning Cycle is performed, volume of ink cleared = Med./Rubbing = Off.
3. [KK2] - Strong Cleaning Cycle is performed, volume of ink cleared = High/Rubbing = On.
4. [Mnt. K/C]: -
5. [Mnt. LC/LM]: -
6. [Mnt. M/Y]: -
4. [Init. Fill] - Perfoms initial fill cycle.
Self Diagnostic Mode Options, cont.
1. Use the [SelecType] or [Paper
Source] to move up or down the menu.
2. Pressing the [Enter] button will move
you into the sub menu.
3. Pressing the [Pause] button will
move you back one menu item.
1. [Check Ptn] - Prints out the current adjustment patterns.
2. [Adj. Variables] - Prints out the adjustment variables. Also lists feed length, firmware, error information.
3. [Check Ptn V1] - Prints out the current adjustment patterns for Variable Shot 1.
4. [Check Ptn V2] - Prints out the current adjustment patterns.for Variable Shot 2
1. [Initialize] - Initializes specific or all parameter items. Refer to the service manual for list.
2. [Update] - Allows you to update certain parameter items. Refer to the service manual for list.
3. [Display] - Displays parameter items. Refer to service manual for list
THIS MENU IS FOR FACTORY USE ONLY. This menu tests the operation of printer components and should not be performed during field ser-
vice.