Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Image Quality Diagnosis and Repair Printer Component, Software Item, LCD Display, Printer Button Page 69.
8. Perform Paper Feed Belt Tension Adjustment.
9. Perform the Feed Length Adjustment.
10. Verify that the printer doesn't pause during printing (caused by a slow computer).
10.1 If the printer pauses, it can create a horizontal band (especially on pigment ink printers). To minimize the
problem:
10.1.1 Verify that the Printer’s Interface is sufficiently fast.
10.1.1.1 Use Fire Wire when not using the Photo Accelerator option ( Non Epson Rips or Drivers)
10.1.2 Set Spool Settings within the Driver Properties
10.1.2.1 Select Start printing after last page is spooled
10.1.3 Set High Speed OFF within the printer driver.
11. For UltraChrome Printers only, perform the Paper Feed Adjustment (Driver or SelecType).
NOTE: (This adjustment is the responsibility of the User. Adjustment must be performed from the
customer’s computer. The compensation value is attached to the driver.)
12. Verify correct Head ID (Print Head calibration value)
12.1 Compare the label on the Print Head and “Head ID” value located in the Adjustment section of the Self-
Diagnostic Mode.
13. Verify that the printer doesn't pause during printing (caused by a slow computer).
13.1 If the printer pauses, it can create a horizontal band (especially on pigment ink printers). To minimize the
problem:
13.1.1 Set Spool Settings within the Driver Properties
13.1.1.1 Select Start printing after last page is spooled
13.1.2 Set High Speed OFF within the printer driver.