Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Image Quality Diagnosis and Repair Printer Component, Software Item, LCD Display, Printer Button Page 68.
4.2 Set to the appropriate setting to match the media (default is Standard)
4.3 Verify that the platen gap is being set to the proper position by observing the Platen Gap HP Flag.
4.3.1 Inspect Thickness Sensor Actuator for proper position.
4.3.2 Adjust if required.
5. Verify the Printer’s Driver type and settings.
5.1 Non-Epson RIPS and Drivers
5.1.1 Verify that they support paper types.
5.1.1.1 If they do not, saturation and banding issues are probable.
5.1.1.1.1 Adjust paper settings using the SelecType Paper Config menu.
5.1.2 Verify that they support MicroWeave
5.1.2.1 If they do not orizontal banding is probable.
5.2 Epson Printer Driver settings.
5.2.1 Set Resolution (1440 High Speed- OFF for best quality)
5.2.1.1 Slight banding may occur at lower resolutions. That is within the printer's specifications.
5.2.2 Verify that MicroWeave is enabled.
5.2.3 Verify Screening Method (Error Diffusion is the best choice).
5.2.4 Verify Paper settings.
5.2.4.1 Type (Plain, Semi-Gloss, Luster, etc.)
5.2.4.2 Configuration (Paper Thickness, Suction, etc.)
6. Verify media and ink vendors.
6.1 Non-Epson ink and media can result in saturation and banding issues.
7. Inspect Paper Feed Encoder Disc for cleanliness.