Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Control Panel Map Page 6.
1. Use the [SelecType] or [Paper
Source] to move up or down the menu.
2. Pressing the [Enter] button will move
you into the sub menu.
3. Pressing the [Pause] button will
move you back one menu item.
Self Diagnostic Mode Options
1. Check: Test
2. Check: Adjustment
3. Check: Cleaning
4. Check: Print
5: Check: Parameter
6. Check: Life
1. [Version] - (Checks firmware version, dip sw. settings and control panel & main board versions.
2. [Panel] - (Checks control panel buttons, LCD display and LED indicators.
3. [Sensor] - (Checks all optical and physical switches - On/Off, Open/Close)
4. [Encoder] - (Checks CR and PF motor encoders)
5. [Fan] - (Checks fans - On/Off)
6. [Elec.] - (Checks maintenance record and fatal error history)
7. [D/A Revision.] - (Factory Use Only - head voltage correction)
8. [Head Signal] - (Factory Use Only - head pulse check)
9. [CSIC] - Checks the CSIC information for the ink cartridges and maintenance tank
10. [Actuator] - Checks the cutter actuator
11. [Actuator 2] - Checks the cutter solenoid and pump motor
When in the sub menu of each item, pressing the [Pause] button will back up one menu.
1. [Check Skew] - Checks for paper skew.
2. [Input Rank]: - Allows you to input the Head Rank.
3. [Check Nozzle]: - Prints a detailed nozzle check, horizontal and vertical pattern.
4. [Adj:Offset Adj.]: - Calibrates the laser system used in nozzle detection.
5. [Adj:Det. Res.]: - Tests and prints the results of the nozzle detection system.
6. [Cut Adj.]: - Allows adjustment of cutter pressure.
7. [Adj:A13 Slant]: -Head Angular magenta against black .
8. [Adj:A123 Slant]: - Head linear test.
9. [Adj: B123 Slant]: - Head linear test.
10. [Bi-D]: - Prints a pattern to allow for adjustment for Bi-D (Double Weight Matte, VSD1).
11.[Head LR Adj.]: - Prints a pattern to allow for adjustment of the Head Gap (Head LR).
12. [Copy Param.]: - Copies parameters to backup area of NVRAM.
13. [Bi-D2]: - Prints a pattern to allow for adjustment for Bi-D2 (Photo Glossy Paper, VSD2).
14. [Feed Adj. T&B]: - Prints a pattern and allows adjustment for 1000mm feed length.
15. [Adj: Top & Bottom]: - Prints a pattern to allow adjustment for top and bottom margin.
16. [Adj: Rear Sensor Pos.] - Allows for adjustment of the rear sensor.
17. [Test Print] - Prints pattern of all adjustment variables.
18. [Clean Head] - Performs ink drain function. This process should only be done during refurbishment of product.
19. [Counter Clear] - Clears ink flag counter to 0.
When in the sub menu of each item, pressing the [Pause] button will back up one menu.
Go to Page 9