Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Firmware: Updating From DOS Printer Component, Software Item, LCD Display, Printer Button Page 58.
Firmware: Updating From DOS
Firmware File Example: MP_231A_181A_0517.IPL
The latest Firmware file may be different than the example use in this procedure.
The latest Firmware file should always be used.
1. Connect the Printer to the PC via a Parallel Printer Cable.
2. Copy the firmware file to the ROOT directory of you Hard Drive.
3. Boot your Computer in DOS mode.
4. Ensure that you are logged to C:\
5. Type: copy (name of firmware file.extension) lpt1:/b (do not press the Enter key)
5.1 Example: copy MP_231A_181A_0517.IPL lpt1:/b
Note: Step 4 prepares the computer to send the firmware. It is important to send the file quickly after
preparing the printer to receive it. At this point, when the Enter key is pressed, the file will be sent.
6. Turn on the Printer while holding down the Cleaning + Paper Source + Cut/Eject buttons.
6.1 The display will read F/W Download
7. Press the Enter key on the PC key to start the firmware update.
7.1 Once completed, the display will read Update Complete and all Control Panel LED’s will be ON.
8. Turn off the Printer.