Service manual

Stylus Pro 10600 Field Repair Guide 7/29/04
Epson Pro Graphics 24” Test Print Directions Printer Component, Software Item, LCD Display, Printer Button Page 48.
3.2 Inspect the Nozzle Check Test Print.
3.2.1 Verify that each Nozzle is firing.
3.2.1.1 Pay special attention to the Yellow Nozzles (they are hard to see, but will make a
difference in the quality of the test print).
3.2.2 Verify that each Nozzle is firing straight (not deflected)
3.2.2.1 Using a magnifier to compare the spacings of each Nozzle, to the spacing of the others.
3.2.3 If there are missing or deflected Nozzles, perform a cleaning cycle.
3.3 Repeat steps 3.1 and 3.2 until the Nozzle Check Pattern is perfect.
If submitting prints to EPSON for evaluation, please include the final nozzle check pattern.
4. Verify that the Printers Electronic Adjustments are correct.
4.1 Perform the Print Head Alignment function located on the Utility Tab of the Printer Driver.
If submitting prints to EPSON for evaluation, please include a print out of the final adjustment patterns.
Printing the Test Print File
The Test Print file requires Acrobat Reader 5.0 or later. The Security Level is set on the Test Print File to
allow opening, filling in the form, and printing only. Attempting to use an earlier version of Acrobat will
result in an Error Message.
The screen shot examples taken from the STYLUS Pro 7600 may not be similar to your specific model
and driver, however all the features described are available in all EPSON Drivers.
1. Fill out the Form.
1.1 Use the Acrobat Magnifying Tool to enlarge the Form section of the Test Print.
1.2 Use the Acrobat Hand Tool to check boxes and select fields for entering text.
1.3 It is important that all the information requested by the form is filled out completely and accurately.